![]() This also appeared after the Office 2013 install.Īny comments would be greatly appreciated. "Yes" I just keep getting the same dialogue popping up. Also I often (not always) get an message when saving files that the Calculation (before save) has been interrupted and asks if I want to "Complete Calculation" before saving which I answer "No" and it saves. All macros will complete successfully if I repeatĢ. Steps to Enable Your Personal Macro Workbook Navigate to your Excel Options (File tab > Options) Click the Add-ins menu on the left-hand side. Same can be configured using Group policy. The macros are never stopping at the same spot or on the same VBA code. Click on File -> Options - > Trust Center -> Trust Center Settings -> Macro Settings -> Enable all macros. Incidentally the macros continue to execute after I hit the "Continue" key on the VBA dialogue. In the error dialog box, click Debugīreak mode, Continue to resume, or End to stop execution." Microsoft: "A CTRL+BREAK (Microsoft Windows), ESC (Microsoft Excel) or COMMAND+PERIOD (Macintosh) key combination has been encountered. ![]() Is what Microsoft has to say about it, but I'm not entering any break code keys on the key board. Enter a name for the workbook in the File Name field, and then select Excel Macro-Enabled. ![]() I keep getting the "Code execution has been interrupted" error. Click File on the Excel ribbon bar, and then click Save As. I have set the macro security setting to "Enable" all macros and the workbooks in question are of the. Change the Store macro in: option from This Workbook to Personal. For reference: Enable or disable macros in Office for Mac. Click the Record Macro button on the Status Bar in the lower-left corner of Excel. Caution: This will allow ALL macros, both good and bad, to run without any further warning. Click Preferences Click Security & Privacy To allow all macros to run select the Enable all macros radio button. Then, in the Customize the Ribbon section, under Main Tabs, check the Developer check box, and press OK. Click the Word, Excel, or PowerPoint menu as appropriate. ![]() In Excel 2010, Excel 2013, or Excel 2016, click Enable Content as shown by in figures 5 and 6 Fig 5. Excel 2007 security options select the Enable this content option 3.2 Excel 2010, Excel 2013 and Excel 2016. Before you start working on macros you should enable the Developer tab, go to Excel > Preferences. Excel 2007 macro warning click the Options button Fig 4. I installed Office 2013 a week ago and I'm having the following two issues: Hi CarolineSykes-Lorenz, Thanks for posting in the forum.
0 Comments
Leave a Reply. |